TM 5-3740-214-14
Table 2-1. Operator Preventative Maintenance Checks and Services (Continued)
B - Before
D - During
A - After
INTERVAL
FOR READINESS REPORT-
ITEM
ITEM TO BE INSPECTED.
ING, EQUIPMENT IS NOT
NO.
B
D
A
PROCEDURE
READY/AVAILABLE IF:
Figure 2-16. Control Panel Installation
10
CONTROL PANEL
a. Make sure control panel is securely fastened to vehicle
The control panel is damaged
floor.
b. Inspect control panel components for broken or
cracked glass.
c. Make sure control panel is set vertically in the vehicle.
The control panel is tilted
at an angle
(1) Loosen universal screws.
(2) Adjust control panel to a vertical position.
(3) Tighten universal screws.
d. Check panel light.
(1) Turn aerosol generator ignition switch ON.
(2) Turn light ON. If it does not operate, replace
light bulb. If it still does not operate, notify your
supervisor.
2-13
