TM 5-3655-214.1 3&P
4-16. STARTER AND CABLES
This task covers:
a. Removal
c. Repair/Replacement
b. Inspection
d. Installation
INITIAL SETUP
Equipment
Condition
Applicable Configurations
Para
Condition Description
All
Equipment is OFF
Test Equipment
None
Special Tools
Special Environmental Conditions
None
None
Materials/Parts
General Safety Instructions
None
Observe Warnings and
Cautions
Personnel Required
MOS 52C
LOCATION/ITEM
ACTION
REMARKS
REMOVAL
WARNING
Make certain that electrical power has been disconnected.
1. Starter
a. Refer to illustration at the end of this
section and remove cover (1).
b. Disconnect terminals on wiring harness
(2) and remove wiring harness.
c.
Disconnect terminals on power cable
(3) and remove cable.
d. Remove four nuts (4), four flat washers,
(5) four lockwashers (6), four screws (7)
and starter (8).