TM 5-3655-2141 3&P
4-13. MOTOR ASSEMBLY
This task covers:
a. Removal
c. Replacement
b. Test
d. Installation
INITIAL SETUP
Equipment
Condition
Applicable Configurations
Para
Condition Description
All
Equipment is OFF
Test Equipment
Multimeter, 0 to 500V
SN 6625-00-998-6084
Special Tools
Special Environmental Conditions
None
None
Materials/Parts
General Safety Instructions
None
Observe Warnings and
Cautions
Personnel Required
MOS 52C
LOCATION/ITEM
ACTION
REMARKS
REMOVAL
1. Motor
WARNING
Make certain that the electrical power source has been disconnected.
a. Remove motor pulley.
b. Refer to illustration at end of this sec-
tion and disconnect wiring harness (1).
c.
Remove four nuts (2) one ground lug (3),
four flat washers (4) and four lock-
washers (5) that attach motor (6) to skid
base.
d. Remove motor.