TM 3-6665-329-13&P
This task covers:
Removal.
a.
Installation.
b.
INITIAL SETUP
Tools:
Electronic equipment tool
kit TK-100/G
NOTE
This procedure applies to all test set toggle switches.
Removal.
a.
(1) Remove lid and panel assembly (para 3-11b steps 1 thru 8).
(2) Remove wires (1). If removing OFFSET INPUT switch, unscrew three screws (2),
Iockwashers (3) and remove circuit card assembly.
(3) Remove nut (4) and switch (5).
Installation.
b.
(1) Remove nut (4).
(2) Adjust nut (6) until threads extend approx. 1/16 inch above panel assembly.
(3) Secure toggle switch (5) with nut (4).
(4) Using FO-2 as a guide, connect wires (1).
(5) If OFFSET INPUT switch was replaced, install circuit card assembly with three screws
(2) and Iockwashers (3).
(6) Install panel assembly and lid (para 3-11c steps 4 thru 8 and 20).
3-84