TM 10-5410-228-24
(9)
Secure two lockplate assemblies (14) to outside door frame assembly (4) with two hand knobs
(11), two flat washers (12), two Teflon washers (13), two flat washers (10) and two new cotter
pins (9) (Item 68, Appx E). Leave room for TALP rail assemblies to slide in place between the
two lockplate assemblies (14) and outside door frame assembly (4).
(10) Secure clamp latch (1) to retaining clamp (2) with six screws (8) and six new self-locking nuts (7)
(Item 48, Appx E).
(11) Position TALP tunnel fabric (3) over outside door frame assembly (4), ensuring four grommets
(5) engage pins (6).
(12) Position retaining clamp (2) over TALP tunnel fabric (3) and outside door frame assembly (4)
and close clamp latch (1).
c.
Repair (Refer to Figure 3-29)
See para 3.10.1 for repair of holes, cuts, or tears in fabric of outside TALP door.
Inside Door Assembly.
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Disassembly (Refer to Figure 3-29)
(1)
Release clamp latch (35) and remove retaining clamp (36) securing TALP tunnel fabric (37) to
inside door frame assembly (38).
(2)
Remove fabric (37) from inside door frame assembly (38) by slipping four grommets (39) over
pins (40) attached to inside door frame assembly (38).
(3)
Remove six self-locking nuts (41) and six screws (38) securing clamp latch (35) to retaining
clamp (36). Discard six self-locking nuts (41).
(4)
Remove two cotter pins (43), two flat washers (44), two hand knobs (45), two flat washers (46)
and two Teflon washers (47) securing two lockplate assemblies (48) to inside door frame
assembly (38). Discard two cotter pins (43).
(5)
Remove five screws (49), five flat washers (50), and five self-locking nuts (51) securing door
hinge (52) to inside door frame assembly (38). Discard five self-locking nuts (51).
(6)
Remove four screws (56), four flat washers (57), and four self-locking nuts (55) securing door
hinge (55) to door weldment (60). Discard four self-locking nuts (55).
(7)
Remove two nuts (57), two lockwashers (58) and latch cam (59) from threaded post of latch (60).
(8)
Remove two screws (61) and two lockwashers (62) securing latch (60) to door weldment (56).
(9)
Remove gasket (63) from inside surface of door weldment (56). Discard gasket (63).
Alcohol solvents are flammable and give off harmful vapors. Use solvents sparingly and only
in well ventilated area. Avoid prolonged breathing of vapors. Keep away from heat, sparks,
open flames.
(10) Drill out two rivets (64) and remove hose guard (65) from inside door frame assembly (38).
(11) Clean gasket adhesive residue from surface of door weldment (56) with rag dampened with
alcohol.
