TM 10-5410-228-24
This task covers:
a. Disassembly
c. Repair
b. Assembly
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
TALP airlock door assemblies removed
Repair (Item 38, Appendix B)
(reference TM 10-5410-228-10).
Drill, Electric (Item 6, Appendix B)
TALP rail assemblies removed (reference
Drill Set (Item 5, Appendix B)
TM 10-5410-228-10).
Goggles (Item 17, Appendix B)
Riveter, Blind, Hand (Item 34, Appendix B)
References:
TM 10-5410-228-10
Materials/Parts:
Materials/Parts: (Cont.)
Spare Parts Kit (TM 10-5410-228-10)
Eighteen Self-locking Nuts (Item 44, Appendix E)
Isopropyl Alcohol (Item 12, Appendix C)
Two Blind Rivets (Item 76, Appendix E)
Rubber Gloves (Item 25, Appendix C)
Twelve Self-locking Nuts (Item 48, Appendix E)
Adhesive (Item 9, Appendix C)
Four Cotter Pins (Item 68, Appendix E)
Wiping Rags (Item 39, Appendix C)
NOTE
The TALP has two airlock door assemblies: an outside door assembly and an inside door
assembly.
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
Outside Door Assembly.
a. Disassembly (Refer to Figure 3-29)
(1)
Release clamp latch (1) and remove retaining clamp (2) securing TALP tunnel fabric (3) to
outside door frame assembly (4).
(2)
Remove fabric (3) from outside door frame assembly (4) by slipping four grommets (5) over pins
(6) attached to outside door frame assembly (4).
(3)
Remove six self-locking nuts (7) and six screws (8) securing clamp latch (1) to retaining clamp
(2). Discard six self-locking nuts (7).
(4)
Remove two cotter pins (9), two flat washers (10), two hand knobs (11), two flat washers (12)
and two Teflon washers (13) securing two lockplate assemblies (14) to outside door frame
assembly (4). Discard two cotter pins (9).
(5)
Pull hand knob (15) from bell timer (16).
(6)
Remove nut (17) and washer (18) securing bell timer (16) and dial (19) to outside door frame
assembly (4).
(7)
Remove five screws (20), five flat washers (21), and five self-locking nuts (22) attaching door
hinge (23) to outside door frame assembly (4). Discard five self-locking nuts (22).
(8)
Remove four screws (24), four flat washers (25), and four self-locking nuts (26) attaching door
hinge (23) to door weldment (27). Discard four self-locking nuts (26).
(9)
Remove two nuts (28), two lockwashers (29) and latch cam (30) from threaded post of latch (31).
