TM 10-5410-228-24
3.10.2 TALP Airlock Door Assembly Repair Continued.
NOTE
Two screws and two lockwashers are supplied with latch.
(10) Remove two screws (32) and two lockwashers (33) securing latch (31) to door weldment (27).
NOTE
Only remove gasket if damaged or worn.
(11) Remove gasket (34) from inside surface of door weldment (27). Discard gasket (34).
Alcohol solvents are flammable and give off harmful vapors. Use solvents sparingly and only
in well ventilated area. Avoid prolonged breathing of vapors. Keep away from heat, sparks,
open flames.
(12) Clean gasket adhesive residue from surface of door weldment (27) with rag dampened with
alcohol.
b. Assembly (Refer to Figure 3-29)
Adhesives and cleaners are flammable and give off harmful vapors. Use adhesive and cleaner
sparingly and only in well ventilated area. Avoid prolonged breathing of vapors. Keep away
from heat, sparks, open flames. Wear gloves when handling adhesive and cleaner.
NOTE
Apply new gasket to clean, dry surface only. Clean adhesive residue from door weldment
with rag dampened with alcohol. Allow door weldment to dry completely before applying new
gasket.
(1)
Remove protective tape backing from new gasket (34) and secure new gasket (34) around inside
edge of door weldment (27) with adhesive.
NOTE
Two screws and two lockwashers are supplied with latch.
(2)
Secure latch (31) to door weldment (27) with two screws (32) and two lockwashers (33).
NOTE
Two nuts, two lockwashers, and latch cam are supplied with latch.
(3)
Install two nuts (28), two lockwashers (29) and latch cam (30) onto threaded post of latch (31).
(4)
Secure door hinge (23) to door weldment (27) with four screws (24), four flat washers (25), and
four nuts (26) (Item 44, Appx E).
(5)
Secure door hinge (23) to outside door frame assembly (4) with five screws (20), five flat washers
(21), and five nuts (22) (Item 44, Appx E).
(6)
Move two nuts (28) as necessary to adjust position of latch cam (30) on latch (31) to ensure latch
(31) holds door weldment (27) securely in place in outside door frame assembly (4) when the
door weldment (27) is closed.
(7)
Secure dial (19) and bell timer (16) to outside door frame assembly (4) with washer (18) and nut
(17). Shaft flats on bell timer should be vertical and zero on dial should be at 12 o'clock.
(8)
Push knob assembly (15) onto bell timer (16). Ensure pointer on knob assembly (15) points to
zero on dial (19).
3-154
