TM 10-5410-228-24
(18) Install connector (12) on adapter (13), finger tight.
(19) Torque connector (12) on adapter (13) to 220 15 in.-lb (18 1 ft-lb).
(20) Check tube assembly (6) sealing surfaces for damage or material build up. Clean any material
build up with clean, lint-free cloth. If required, replace tube assembly (6) per 3.9.11.
(21) Remove plug from union on ECU (3) partition wall. Refer to para 3.9.11 for location of union.
(22) Install tube assembly (6) on connector (12) and on union on ECU (3) partition wall, finger tight.
Adjust position of tube assembly (6) as required.
(23) Torque both ends of tube assembly (6) to 320 25 in.-lb (27 2 ft-lb).
(24) Check elbow (10) sealing surfaces for damage or material build up. If required, replace elbow
(10) or clean any material build up with clean, lint-free cloth.
Ensure O-rings (16 and 11) are seated and retained properly.
(26) Lubricate O-rings (16 and 11) with a light coating of hydraulic fluid.
(27) Remove plug in port of hydraulic motor (8). Install elbow (10) on hydraulic motor (8), finger
tight.
(28) Check tube assembly (5) sealing surfaces for damage or material build up. If required, clean any
material build-up with clean, lint-free cloth. If necessary, replace tube assembly (5) per para
3.9.11.
(29) Remove plug from union on ECU (3) partition wall. Refer to para 3.9.11 for location of union.
(30) Install tube assembly (5) on elbow (10) and on union on ECU (3) partition wall, finger tight.
Adjust position of tube assembly (5) and elbow (10) as required.
(31) Torque elbow (10) on hydraulic motor (8) to 720 25. in.-lb (60 2 ft-lb).
(32) Torque both ends of tube assembly (5) to 480 25 in.-lb (40 2 ft-lb).
(33) Check elbow (7) sealing surfaces for damage or material build up. If required, replace elbow (7)
or clean any material build up with clean, lint-free cloth.
Ensure O-rings (15 and 9) are seated and retained properly.
(35) Lubricate O-rings (15 and 9) with a light coating of hydraulic fluid.
(36) Remove plug in port of hydraulic motor (8). Install elbow (7) on hydraulic motor (8), finger tight.
(37) Remove plug from union on ECU (3) partition wall. Refer to para 3.9.11 for location of union.
(38) Install tube assembly (4) on elbow (7) and on union on ECU (3) partition wall, finger tight.
Adjust position of tube assembly (4) and elbow (7) as required.
(39) Torque elbow (7) on hydraulic motor (8) to 720 25 in.-lb (60 2 ft-lb).
(40) Torque both ends of tube assembly (4) to 480 25 in.-lb (40 2 ft-lb).
(41) Screw strainer (1) onto nipple (2).
3-57
