TM 10-5410-228-24
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
Power shut off. Power panel and rear control panel
Repair (Item 38, Appendix B)
tagged.
Gloves (Item 16, Appendix B)
ECV parking brake set.
Goggles (Item 17, Appendix B)
ECU covers and doors opened or removed, as
11/16 Inch Crowfoot Wrench (Item 53, Appendix B)
required (see para 2.14.1).
13/16 Inch Crowfoot Wrench (Item 54, Appendix B)
Hydraulic system drained (see para 2.14.3).
15/16 Inch Crowfoot Wrench (Item 55, Appendix B)
Plenum removed (see TM 10-5410-228-10).
1-3/8 Inch Crowfoot Wrench (Item 60, Appendix B)
ECU work platform installed (reference
Torque Wrench (Item 66, Appendix B)
TM 10-5410-228-10).
Materials/Parts:
References:
Antiseize Compound (Item 13, Appendix C)
TM 10-5410-228-10
Hydraulic Fluid (Item 24, Appendix C)
Materials/Parts: (Cont.)
Wiping Rags (Item 39, Appendix C)
Two Lockwashers (Item 20, Appendix E)
Sealant (Item 46, Appendix C)
Two O-rings (Item 51, Appendix E)
Hydraulic Sealant (Item 48, Appendix C)
Two O-rings (Item 57, Appendix E)
Gasket (Figure D-15, Appendix D)
O-ring (Item 55, Appendix E)
Gasket (Figure D-26, Appendix D)
O-ring (Item 56, Appendix E)
Twenty-seven Lockwashers (Item 18, Appendix E)
O-ring (Item 62, Appendix E)
Four Lockwashers (Item 19, Appendix E)
The hydraulic system is pressurized. To prevent injury to personnel, gloves and eye
protection must be worn when working on hydraulic system.
NOTE
A small amount of hydraulic fluid will be released when removing tubes. Collect fluid in cup
or small container and clean any spillage with rags.
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Removal (Refer to Figure 3-12)
(1)
Disconnect tube assembly (1) from elbow (2) on hydraulic motor (3). Remove and discard O-ring
(4) from elbow (2).
(2)
Disconnect tube assembly (5) from elbow (6) on hydraulic motor (3). Remove and discard O-ring
(7) from elbow (6).
(3)
Disconnect tube assembly (8) from connector (9) on adapter (10). Remove and discard O-ring
(11) from connector (9).
