TM 10-5410-228-24
2.18.1 Ballast Assembly Continued.
(6)
Ensure that extrusion assembly (8) aligns with track in lens/screen assembly (7) and ballast
assembly (14) is covered by solid portion. Slide extrusion assembly (8) into lens/screen assembly
(7).
(7)
Install male end cap assembly (1) on luminaire (3). Install lamp (6).
(8)
Install lampholder (4) and female end cap (2) onto luminaire (3).
Figure 2-71. Ballast Removal and Installation.
c.
Test (Refer to Figure 2-72)
(1)
Remove both end caps (1) from luminaire (2).
(2)
Disconnect lampholder (3) by depressing retainer connector (4). Pull lamp (5) out of lens/screen
assembly (6).
(3)
Slide extrusion assembly (7) out of lens/screen assembly (6).
(4)
assembly (7) for cut, loose or exposed wires.
(5)
Test for continuity at power input connection (9) (black and white wire splices).
(6)
Connect lampholder (3) to extrusion assembly (7).
(7)
If continuity exists at power input connection test at lampholder (3), (with switch in ON
position).
NOTE
No continuity at lampholders indicates a faulty ballast assembly or wiring.
(8)
Remove and install new ballast assembly (8).
2-332
