TM 10-5410-228-24
2.18.2 Switch Continued.
b. Installation (Refer to Figure 2-73)
(1)
Insert new switch (11) through paper insulator (13) into cutout in bracket (9).
(2)
Screw switch seal (12) onto threaded toggle sleeve.
(3)
Connect ring terminals (10) to switch (11).
(4)
Install bracket (9) into male end cap (1).
(5)
Slide extrusion assembly (7) into lens/screen assembly (6).
(6)
Install lampholders (4).
(7)
Install male (1) and female (2) end caps over luminaire (3).
c.
Test (Refer to Figure 2-72)
(1)
Refer to paragraph 2.18.1a., steps 1 through 3, to partially disassemble luminaire.
(2)
Test for continuity at the switch connector posts (with switch in ON position).
(3)
If continuity does not exist, replace switch.
Figure 2-73. Switch Removal and Installation
2-334
