TM 10-5410-228-24
This task covers:
a. Disassembly
b. Assembly
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ABS inflated (reference TM 10-5410-228-10).
Repair (Item 38, Appendix B)
Materials/Parts:
Heat Gun (Item 19, Appendix B)
Electrical Insulation Sleeving (Item 23, Appendix C)
Adhesive (Item 11, Appendix C)
a. Disassembly. (Refer to Figure 2-68)
(1) Cut plastic tubing (1) at ABS or TALP fitting (2) and remove plastic tubing (1).
(2) Cut shrink tubing (3) at quick disconnect (4) and remove plastic tubing.
b. Assembly. (Refer to Figure 2-68)
(1) Position an 1.5 inch piece of heat shrink tubing (3) over end of plastic tubing (1).
(2)
Slide plastic tubing (1) over quick disconnect (4) and secure by heating heat shrink tubing (3).
(3)
Secure other end of plastic tubing (1) to ABS or TALP fitting (2) with adhesive.
INSIDE ENDWALL
2
2
3
1
4
1
3
4
