TM 10-5410-228-24
(11) Install terminal lugs on potentiometer (64). Remove tags from wires.
NOTE
Knurled nut and screws supplied with audible alarm. This note applies to steps 15 through
20.
(12) Secure audible alarm (62) to cover (5) with knurled nut (63).
(13) Secure wire lugs (61) to audible alarm (62) with two screws (60). Remove tags from wires.
(14) Secure audible alarm (58) to cover (5) with knurled nut (59).
(15) Secure wire lugs (57) to audible alarm (58) with two screws (56). Remove tags from wires.
(16) Secure audible alarm (54) to cover (5) with knurled nut (55).
(17) Secure wire lugs (53) to audible alarm (54) with two screws (52). Remove tags from wires.
(18) Secure three circuit breakers (48) to cover (5) with twelve flat washers (51), twelve new
lockwashers (50) (Item 15, Appx E) and twelve screws (49).
NOTE
Nuts, lockwashers and flat washers supplied with circuit breaker.
(19) Secure wire lugs (47) to three circuit breakers (48) with flat washers (46), lockwashers (45) and
nuts (44). Remove tags from wires.
(20) Secure four circuit breakers (40) to cover (5) with eight flat washers (43), eight new lockwashers
(42) (Item 15, Appx E) and eight screws (41).
NOTE
Nuts, lockwashers and flat washers supplied with circuit breaker.
(21) Secure wire lugs (39) to four circuit breakers (40) with flat washers (38), lockwashers (37) and
nuts (36). Remove tags from wires.
(22) Secure two circuit breakers (32) to cover (5) with twelve flat washers (35), twelve new
lockwashers (34) (Item 15, Appx E) and twelve screws (33).
NOTE
Nuts, lockwashers and flat washers supplied with circuit breaker.
(23) Secure wire lugs (31) to two circuit breakers (32) with flat washers (30), lockwashers (29) and
nuts (28). Remove tags from wires.
(24) Secure circuit breaker (24) to cover (5) with two flat washers (27), two new lockwashers (26)
(Item 15, Appx E) and two screws (25).
NOTE
Nuts, lockwashers and flat washers supplied with circuit breaker.
(25) Secure wire lugs (23) to circuit breaker (24) with flat washers (22), lockwashers (21) and nuts
(20). Remove tags from wires.
(26) Install two barbed connectors (19) on back of gage PG3 (17).
(27) Install two plugs (18) on side of gage PG3 (17).
(28) Install gage PG3 (17) on front of cover (5).
NOTE
Screws and retainers supplied with gage.
(29) From back of cover (5) secure gage PG3 (17) and four retainers (16) to cover (5) with four screws
(15).
(30) Install barbed connector (13) into LOW port on back of gage PG1 (9).
Change 1
