TM 10-5410-228-24
This task covers:
a. Disassembly
b. Assembly
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
Power shut off, power panel and cab area tagged.
Repair (Item 38, Appendix B)
ECV battery ground cable disconnected
Shop Equipment: Electrical, Equipment
(see TM 9-2320-387-24-1).
(Item 40, Appendix B)
Cover assembly opened and hoses removed from
Extraction Tool (Item 10, Appendix B)
cover assembly (see para 2.13.22).
Guard removed from forward side of rack
Materials/Parts:
(see para 2.13.21).
Solder (Item 51, Appendix C)
Tape (Item 53, Appendix C)
References:
TM 9-2320-387-24-1
Thirty-four Lockwashers (Item 15, Appendix E)
Tie-down Straps (Item 86, Appendix E)
CBPS contains high electrical currents. To prevent electrical shock when working on
electrical system, ensure that power cable is disconnected from power panel and ECV
batteries are disconnected per TM 9-2320-387-24-1. Tag power panel and battery area with
sign that states that the power must remain OFF while work is being performed.
Remove jewelry and observe all safety rules for working around high voltage.
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Disassembly (Refer to Figure 2-44)
(1) Remove connector (1) from back of gauge PG2 (2).
(2) Remove retaining ring (3) securing gage PG2 (2) and spacer ring (4) to cover (5). Remove gage
PG2 (2) from front of cover (5).
(3) Remove two plugs (6) from side of gage PG2 (2).
(4) Remove two barbed connectors (7) from back of gage PG2 (2).
(5) Remove connector (8) from back of gage PG1 (9).
(6) Remove retaining ring (10) securing gage PG1 (9) and spacer ring (11) to cover (5). Remove gage
PG1 (9) from front of cover (5).
(7) Remove two plugs (12) from side of gage PG1 (9).
(8) Remove barbed connector (13) from back of gage PG1 (9).
(9) Remove vent filter plug (14) from back of gage PG1 (9).
(10) Remove four screws (14) and four retainers (15) securing gage PG3 (16) to cover (5). Remove
gage PG3 (17) from front of cover (5).
(11) Remove two plugs (18) from side of gage PG3 (17).
(12) Remove two barbed connectors (19) from back of gage PG3 (17).
(13) Tag wires and remove nuts (20), lockwashers (21) and flat washers (22) securing wire lugs (23)
to circuit breaker (CB10) (24).
Change 1
