TM 10-5410-228-24
2.13.23 Cover Assembly Repair Continued.
(35) Using a small flat tip screwdriver, turn two screws (78) counterclockwise until two retaining
cams (79) lay down.
(36) Remove switch housing (77) and retaining cover (80).
(37) Remove eleven screws (81) securing cover (5).
b. Assembly (Refer to Figure 2-44 and Schematic Figure F-9)
NOTE
Apply tie-down straps as required.
(1)
Install cover (5) with eleven screws (81).
NOTE
Steps 2 through 5 apply to 22 switches. Note correct location of each switch before
installation.
(2)
Push switch housing (77) into cover (5) and retaining cover (80).
(3)
Using small flat tip screwdriver, turn two screws (78) clockwise until two retaining cams (79)
stand up.
Do not install indicator unit without all four lamps installed or short circuit will occur when
power is applied.
NOTE
If installing new switch, install lamps per TM 10-5410-228-10.
(4)
Using extraction tool, carefully squeeze tabs (75) and install indicator unit (76) into switch
housing (77), ensuring that the aligning pin engages hole in switch housing (77).
(5)
Solder leads to back of switch assembly (74). Remove tags from leads.
NOTE
Nut and lockwasher supplied with rotary switch.
(6)
Secure rotary switch (69) to cover (5) with lockwasher (73) and nut (72).
NOTE
Setscrew supplied with knob.
(7)
Place knob (71) (in correct position) on rotary switch (69) and secure by tightening setscrew (70).
(8)
Solder leads to rotary switch (69). Remove tags from leads.
NOTE
Nut and lockwasher supplied with potentiometer.
(9)
Secure potentiometer (64) to cover (5) with lockwasher (68) and nut (67).
NOTE
Setscrew supplied with knob.
(10) Place knob (66) (in correct position) on potentiometer (64) and secure by tightening setscrew
(65).
2-220
