TM
3-6665-316-12
Push M43A1 Interface Cable connector onto Connector P1 until catches
17.
on Connector P1 close on back of M43A1 Interface Cable connector.
Push two catches together until they snap into straight-ahead posi-
tion. Carefully tuck excess cable into receiver ring so that no part
of cable sticks out.
Position case-bottom
assembly
so
USUAL
RESERVICING
INSTRUCTION
plate
18.
is toward you.
Position
case-top assembly and receiver assembly above case-bottom
19.
The words 24 VDC INPUT and AIR' FILTER should be toward
assembly.
you .
20.
Lower receiver until bottom surface
of
receiver
ring
contacts
top
surface of case-bottom assembly.
21.
Engage four latches on case bottom assembly with four catches on
Push down on latch-locking tabs to lock latches.
receiver ring.
NOTE
Do not connect power
source connector to
24
VDC INPUT connector
until so instructed.
22.
If BA3517/U Battery is installed with
the M43A1 Detector, begin at
If BA3517/U Battery is not
installed with M43A1 Detector,
Step 23.
go to Step 25.
23.
Remove
extender
cable
from
transit case.
24.
Push extender cable connector
(12) and
BA3517/U Battery
Power
Cable
they are
fully seated.
connector (13) together until
2-13