TM
3-6665-316-12
2-6.
OPERATING PROCEDURES (continued)
Be sure the transmitter antenna is pointing straight up, the OPERATING
b.
Switch
PROCEDURES plate is toward you and you are facing the receivers.
Release the switch.
to "OPR" and hold there for 5 seconds.
c.
Repeat
Steps
a
and
b
for
each
of
the
receiver/detectors.
NOTE
If one or more detectors fail to
alarm,
re-
transmit from the same location.
If none of the detectors alarm, initiate troubleshooting
procedure
"No
d.
receivers respond to transmitter", (Paragraph 4-9e).
e.
If any of the detectors do not alarm, initiate troubleshooting procedure
"One to three receivers do not respond to transmitter", (Paragraph 4-9f).
f.
If one or more detectors alarm without a signal from the transmitter,
initiate troubleshooting procedure "One or
more detectors continue to
alarm after power has been applied and detector has been reset",
(Paragraph 4-9b).
5.
Perform
Preparation
for
Movement
procedures
(Paragraph
2-7).
2-18
