Strip approximately 3/8 inch of the rubber coating off the black and white
Lug terminals (2)
wires, and insert the wires through two lug terminals (2). Using the proper
tools, crimp two lug terminals (2) onto the two wires.
Electrical wire (3)
nector pin (4) and remove any broken wire strands.
Connector pin (4)
The white wire is held against the inner metal strip and
Strip one inch of the rubber coating off the black wire and bend 1/2 inch of
the outer metal elbow section of the electrical plug
the wire back against itself. Insert the folded black wire into the connector
connector when assembled.
pin (4) and solder.
TM 3-4230-209-30&P
2-185