2-186
TM 3-4230-209-30&P
2-42. POWER CABLE ASSEMBLY (CONT).
LOCATION/lTEM
ACTION
REMARKS
Power Cable Assembly/
Power cable (1)
Strip power cable (1) to the proper length as shown in the illustrations.
With the screws and strap removed from electrical cable clamp (2), slide it
Electrical cable clamp (2)
back on power cable (1) with the screw holes facing the long part of
power cable (1). Fold the bared end of the black wire back against itself.
Insert the folded black wire into the contact of electrical plug
connector (3), solder the connection, and let it cool.
Carefully bend power cable (1) 90 degrees and lay it in one half of electri-
Electrical plug connector (3)
cal plug connector (3) rear section. Aline the keyway with power cable (1)
Screws (4)
Position the white wire (bared part) against the upper part of electrical
plug connector (3). Then place the second half of electrical plug
connector (3) rear section on top, insert two screws (4), and tighten.
Screw electrical cable clamp (2) onto electrical plug connector (3) and
tighten handtight.
