TM 3-4230-209-30&P
2-58
2-17. OUTLET HOSE ASSEMBLY (CONT).
REMARKS
ACTION
LOCATION/lTEM
Outlet Hose Assembly/
Fabricate hose (1) according to figure D-26 for the lower hose reel and
Hose (1)
according to figure D-27 for the upper hose reel. Thread the strap end (2)
Strap end (2)
of each hose clamp (3) through the buckle (4) of the hose clamp (3) twice.
Hose clamps (3)
Slide two hose clamps (3) onto hose (1).
Buckle (4)
Insert stem (5) through the hole in nut (6) and then insert both into hose (1)
Stem (5)
as a unit until the rear of nut (6) is against the end of hose (1). Slide two
Nut (6)
hose clamps (3) over stem (5). Rotate the second hose clamp so that the
buckle (4) is 1800 from the first hose clamp (3) buckle to assure a better
seal. Repeat reassembly procedures for other hose clamps (3).
Insert the strap end (2) into the frame (7) of strap band clamping tool.
Frame (7)
Insert the winder (8) into the frame (7) and insert the strap end (2) through
Winder (8)
the winder (8). Use the ratchet tension wrench (9) to turn the winder (8)
Ratchet tension wrench (9)
and draw the hose clamp (3) tight.
