TM 10-5410-228-24
(2)
Loosen clamp (37) securing one end of hose (38) to blower outlet duct (36).
(3)
Remove three screws (39), three lockwashers (40) and three flat washers (41) securing blower
outlet duct (36) to blower mount (35). Discard three lockwashers (40).
(4)
Remove gasket (42) from blower outlet duct (36). Discard gasket (42).
(5)
Remove four screws (43), four lockwashers (44) and four flat washers (45) securing blower
mount (35) to floor of ECU. Discard four lockwashers (44).
(6)
Loosen clamp (28) and remove sleeve (29) and clamp (28) from blower inlet adapter (46).
(7)
Remove seven screws (47), seven lockwashers (48) and seven flat washers (49) securing blower
inlet adapter (46) and gasket (50) to ECU. Discard seven lockwashers (48) and gasket (50).
(8)
Loosen clamp (51) securing other end of hose (38) to dust ejector (52). Remove hose (38).
(9)
Loosen two clamps (53) securing hose (54) to dust ejector (52) and inertial separator (55) and
remove hose (54) and dust ejector (52).
(10) Remove eight screws (56), eight lockwashers (57) and eight flat washers (58) securing inertial
separator (55) to ECU enclosure. Discard eight lockwashers (57).
b. Installation (Refer to Figure 3-12)
(1)
Secure inertial separator (55) to ECU with eight screws (56), eight new lockwashers (57) (Item
18, Appx E) and eight flat washers (58).
(2)
Secure hose (54) to inertial separator (55) with clamp (53).
(3)
Secure dust ejector (52) to hose (54) with clamp (53).
(4)
Secure one end of hose (38) to dust ejector (52) with clamp (51).
(5)
Feed other end of hose (38) through hole in ECU enclosure wall.
(6)
Secure new gasket (50) and blower inlet adapter (46) to ECU with seven screws (47), seven new
lockwashers (48) (Item 18, Appx E) and seven flat washers (49).
(7)
Secure sleeve (29) on blower inlet adapter (46) by tightening clamp (28).
(8)
Secure blower mount (35) to floor of ECU with four screws (43), four new lockwashers (44) (Item
18, Appx E) and four flat washers (45).
(9)
Install new gasket (42) on blower outlet duct (36).
(10) Secure blower outlet duct (36) to blower mount (35) with three screws (39), three new
lockwashers (40) (Item 18, Appx E) and three flat washers (41).
(11) Secure sleeve (31) to blower outlet duct (36) by tightening clamp (30).
(12) Secure hose (38) to blower outlet duct (36) by tightening clamp (37).
(13) Install centrifugal fan per para 3.9.7.2.
(14) Install hydraulic motor and tube assemblies per para 3.9.7.1.
3-65
