TM 10-5410-228-24
This task covers:
a. Disassembly
c. Assembly
b. Repair
INITIAL SETUP
Equipment Conditions:
Tools/Test Equipment:
Shop Equipment, Automotive Maintenance and
ABS inflated, insulation removed
Repair (Item 38, Appendix B)
(reference TM 10-5410-228-10).
Gloves (Item 16, Appendix B)
ABS Repair Kit (TM 10-5410-228-10, Appendix B)
References:
TM 10-5410-228-10
Materials/Parts:
Adhesive (Item 1, Appendix C)
Sealant (Item 43, Appendix C)
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Disassembly (Refer to Figure 2-66)
(1)
Close seven shutoff valves (1) at air beam input ports (8).
NOTE
If air beam assemblies need to be kept inflated when inflation manifold is disconnected, plug
individual air beam input port when inflation manifold attaching hose is removed.
(2)
Unscrew shelter to airbeam hose assembly (2) from vehicle air flow bulkhead fitting (3).
(3)
Unscrew shelter to airbeam hose assembly (2) from tee check value with shutoff (4).
(4)
In six places, unscrew hose assembly (6) from tee check valve with shutoff (4).
(5)
Unscrew hose assembly (7) from straight check valve with shutoff (5).
(6)
Cut hose off barb on input port (8) of ambulatory door air beam.
