TM 10-5410-228-24
NOTE
Make note of polarity on diodes before removing.
(4)
Tag wires and remove four screws (23), four lockwashers (24) and four flat washers (25)
securing three diodes (26) attached to six terminal lugs (27) and four terminal lugs (28) to
terminal board A17TB1(29).
(5)
Remove four screws (30), four lockwashers (31), four flat washers (32) and four nuts (33)
securing terminal board (29) to relay box (6). Discard four lockwashers (31).
(6)
Remove four screws (34), four lockwashers (35), four flat washers (36) and four nuts (37)
securing electrical connector (1) to relay box (6). Discard four lockwashers (35).
(7)
Remove electrical locknut (38) securing chase nipple (39) and electrical bushing (40) to relay box
(6).
c.
Assembly (Refer to Figure 2-40)
(1)
Secure chase nipple (39) and electrical bushing (40) to relay box (6) with electrical locknut (38).
(2)
Secure terminal board (29) to relay box (6) with four screws (30), four new lockwashers (31)
(Item 16, Appx E), four flat washers (32) and four nuts (33).
(3)
If required, cut any damaged terminal lug(s) (27) from diode(s) (26) and crimp new terminal
lug(s) (27) onto wire.
(4)
Secure electrical connector (1) to relay box (6) with four screws (34), four new lockwashers (35)
(Item 15, Appx E), four flat washers (36) and four nuts (37).
(5)
If required, cut any damaged terminal lug(s) (28) from wire and crimp new terminal lug(s) (28)
onto wire.
NOTE
Screws, lockwashers, and flat washers supplied with terminal board.
(6)
Secure three diodes (26) attached to six terminal lugs (27) and four terminal lugs (28) to
terminal board (29) with four screws (23), four lockwashers (24) and four flat washers (25).
Remove tags from wires.
(7)
Secure relay A17K1 (14) to relay box (6) with two screws (19), two new lockwashers (20) (Item
17, Appx E), two flat washers (21) and two nuts (22).
(8)
If required, cut any damaged terminal lug(s) (18) from wire and crimp new terminal lug(s) (18)
onto wire.
NOTE
Nuts, lockwashers, and flat washers supplied with relay.
(9)
Secure four terminal lugs (18) and wires to relay A17K1 (14) with two nuts (15), two
lockwashers (16) and two flat washers (17). Remove tags from wires.
(10) If required, cut any damaged terminal lug(s) (13) from wire and crimp new terminal lug(s) (13)
onto wire.
NOTE
Nuts, lockwashers, and flat washers supplied with relay.
(11) Secure two terminal lugs (13) and wires to relay K1 (14) with two nuts (10), two lockwashers
(11) and two flat washers (12). Remove tags from wires.
2-209
