TM 10-5410-228-24
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
Chair removed (see para 2.13.12)
Drill, Electric (Item 6, Appendix B)
Drill Set (Item 5, Appendix B)
References:
TM 10-5411-224-14
Goggles (Item 17, Appendix B)
Riveter, Blind, Hand (Item 34, Appendix B)
Materials/Parts: (Cont.)
Collar Set, Drill Stop (Item 2, Appendix B)
Wiping Rags (Item 39, Appendix C)
Grommet (Item 5, Appx E)
Materials/Parts:
Adhesive (Item 6, Appendix C)
Eight Blind Rivets (Item 78, Appendix E)
Isopropyl Alcohol (Item 12, Appendix C)
Rubber Gloves (Item 25, Appendix C)
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
NOTE
The following maintenance procedures can be used for both passenger side and driver side
storage box assemblies.
a. Removal (Refer to Figure 2-35)
Drill out eight rivets (1) securing storage box (2) to LMS.
NOTE
Grommet is only located on the passenger side storage box assembly.
b. Disassembly (Refer to Figure 2-35)
Remove grommet (3) from storage box (2). Discard grommet (3).
c.
Assembly (Refer to Figure 2-35)
Alcohol solvents are flammable and give off harmful vapors. Use solvents sparingly and only
in well ventilated area. Avoid prolonged breathing of vapors. Keep away from heat, sparks,
open flames.
(1)
Clean appropriate area on storage box (2) with rag dampened with alcohol.
