TM 10-5410-228-24
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions:
Tools/Test Equipment:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
Materials/Parts: (Cont.)
Materials/Parts:
Eight Lockwashers (Item 17, Appendix E)
Adhesive (Item 6, Appendix C)
Wiping Rags (Item 39, Appendix C)
Isopropyl Alcohol (Item 12, Appendix C)
Rubber Gloves (Item 25, Appendix C)
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Removal (Refer to Figure 2-33)
(1)
Remove eight screws (1), eight lockwashers (2) and eight flat washers (3) securing back
assembly (4) to LMS. Discard eight lockwashers (2).
(2)
Carefully lift seat assembly (5) from storage box assembly (6).
(3)
Remove fastener hook (7) from seat assembly (5) and fastener loop (8) from top of storage box
assembly (6).
b. Installation (Refer to Figure 2-33)
Alcohol solvents are flammable and give off harmful vapors. Use solvents sparingly and only
in well ventilated area. Avoid prolonged breathing of vapors. Keep away from heat, sparks,
and open flames.
(1)
Clean adhesive residue from top of storage box assembly (6) with rag dampened with alcohol.
(2)
Secure fastener loop (8) to top of storage box (6) and fastener hook (7) to bottom of seat assembly
(5) with adhesive.
(3)
Position and press seat assembly (5) onto top of storage box assembly (6).
NOTE
Longer screws (1) are used on side towards front of shelter. More than one washer (3) may
be required with this screw to keep it from bottoming out.
(4)
Secure back assembly (4) to LMS with eight screws (1), eight new lockwashers (2) and eight flat
washers (3).
