TM 10-5410-228-24
(6)
Remove two jumpers (17) from terminal board assemblies TB1 and TB2 (13).
(7)
Remove four screws (18) and four nuts (19) securing terminal board assemblies TB1 and TB2
(13) to terminal board mount channel on front panel assembly (4).
(8)
Remove eight screws (20), eight flat washers (21), eight lockwashers (22) and eight nuts (23)
securing two task lamp assemblies (24) to forward light box assembly (5). Tag wires and remove
two task lamp assemblies (24). Discard eight lockwashers (22).
(9)
Remove four screws (25), four flat washers (26), four lockwashers (27) and four nuts (28)
securing connector (6) to terminal board mount channel on front panel assembly (4). Discard
four lockwashers (27).
(10) Remove three nuts (29), three lockwashers (30) and three flat washers (31) securing lamp frame
assembly (32) to front panel assembly (4). Discard three lockwashers (30).
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
(11) Drill out five rivets (33) securing hinge (34) to forward light box assembly (5) and five rivets (33)
securing hinge (34) to front panel assembly (4).
c.
Assembly (Refer to Figure 2-37)
NOTE
Reference TM 10-5411-224-14 for general repair procedures using rivets.
(1)
Secure hinge (34) to front panel assembly (4) with five rivets (33) (Item 78, Appx E) and to
forward light box assembly (5) with five rivets (33) (Item 78, Appx E).
(2)
Secure lamp frame assembly (32) to front panel assembly (4) with three flat washers (31), three
new lockwashers (30) (Item 17, Appx E) and three nuts (29).
(3)
Secure connector (6) to terminal board mount channel on front panel assembly (4) with four
screws (25), four flat washers (26), four new lockwashers (27) (Item 14, Appx E) and four nuts
(28).
(4)
Secure two task lamp assemblies (24) to forward light box assembly (5) with eight screws (20),
eight flat washers (21), eight new lockwashers (22) (Item 16, Appx E) and eight nuts (23).
Remove tags from wires.
(5)
Secure terminal board assemblies TB1 and TB2 (13) to terminal board mount channel on front
panel assembly (4) with four screws (18) and four nuts (19).
(6)
Install two jumpers (17) on terminal board assemblies TB1 and TB2 (13).
(7)
If required, cut any damaged terminal lug(s) from wires and crimp new terminal lug(s) onto
wires.
(8)
Secure terminal lugs to terminal board assemblies TB1 and TB2 (13) with eight nuts (14), eight
new lockwashers (15) (Item 15, Appx E) and eight flat washers (16). Remove tags from wires.
(9)
Install cover assemblies (12) on terminal board assemblies TB1 and TB2 (13).
(10) Install lamp (10) in lamp retainer (11).
(11) Secure wires to lamp (10) with two screws. Remove tags from wires.
(12) Install lamp (10) and lamp retainer (11) on front panel assembly (4).
2-197
