TM 10-5410-228-24
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV engine off, power off, parking brake set.
Repair (Item 38, Appendix B)
ABS deflated and unrolled or ABS inflated
Caulking Tool, Hand (Item 18, Appendix B)
(reference TM 10-5410-228-10).
Drill, Electric (Item 6, Appendix B)
ABS Manifold disconnected
Drill Set (Item 5, Appendix B)
(see para 2.16.4).
Goggles (Item 17, Appendix B)
References:
Riveter, Blind, Hand (Item 34, Appendix B)
TM 10-5411-224-14
Collar Set, Drill Stop (Item 2, Appendix B)
Materials/Parts: (Cont.)
Materials/Parts:
Isopropyl Alcohol (Item 12, Appendix C)
Seventy-eight Lockwashers (Item 18, Appendix E)
Rubber Gloves (Item 25, Appendix C)
Thirty-one Self-locking Nuts (Item 40, Appendix E)
Wiping Rags (Item 39, Appendix C)
Four Blind Rivets (Item 69, Appendix E)
Sealant (Item 47, Appendix C)
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
The ABS and retainers are easier to replace with the ABS inflated.
a. Removal (Refer to Figure 2-24)
(1) Remove eight screws (1), eight lockwashers (2), eight flat washers (3), eight self-locking nuts (4)
and retaining channel (5), and remove top panel (6) from LMS. Discard eight lockwashers (2)
and eight self-locking nuts (4).
(2) Remove seven screws (7), seven lockwashers (8), seven flat washers (9), seven self-locking nuts
(10), retaining channel (11), side panel (12) and strap (13). Discard seven lockwashers (8) and
seven self-locking nuts (10).
(3)
Remove seven screws (14), seven lockwashers (15), seven flat washers (16), seven self-locking
nuts (17), retaining channel (18), side panel (19) and strap (20) from LMS. Discard seven
lockwashers (15) and seven self-locking nuts (17).
(4)
Remove nine screws (21), nine lockwashers (22), nine flat washers (23), nine self-locking nuts
(24) and retaining channel (25) from LMS. Discard nine lockwashers (22) and nine self-locking
nuts (24).
(5)
Remove ABS from LMS.
(6)
Remove gasket (26) from LMS.
(7)
Remove six screws (27), two screws (28), eight lockwashers (29) and eight flat washers (30)
securing retaining bracket (31). Discard eight lockwashers (29).
(8) Remove seven screws (27), two screws (32), nine lockwashers (29), nine flat washers (30) and
three mounting brackets (33) securing retaining bracket (31). Discard nine lockwashers (29).
NOTE
Bracket and shims are sealed onto LMS with sealant and might require prying.
(9)
Remove retaining bracket (31) and shims (34, 35, 36 and 37) from LMS.
Change 1
