TM 10-5410-228-24
This task covers:
a. Disassembly
b. Assembly
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
Block assembly removed from LMS
Materials/Parts:
(1)
Remove clamp (1) from end of rope (2).
(2)
Pull rope (2) through exit block (3) and lock block (4). Discard rope (2).
(1)
Cut new rope (2) to 51 feet.
NOTE
Do not cross rope.
(2)
Insert end of rope (2) into clamp nut (1) and loop end through small bottom roller of lock block
(4).
(3)
Install clamp halves over loop and tighten clamp nut (1).
(4)
Thread rope (2) through rollers as follows: Right roller on lock block (3), through right roller on
lock block (4), through middle roller on lock block (3), through middle roller on exit block (4),
through left roller on lock block (3), and up through left roller on exit block (4).
(5)
Tie a knot at end of rope (2). Tie second knot six inches from end knot.