TM 5-3740-218-13&P
4-10.
PMCS TABLE
Table 4-1. Unit Level PMCS
NOTE: Within designated interval, these checks are to be performed in the order listed.
M-Monthly
S-Semiannually
A-Annually
ITEM
NO.
INTERVAL
ITEM TO BE
INSPECTED
PROCEDURE
M
S
A
1
Battery
Check for charge. Replace as necessary.
Check terminals for corrosion. Clean as necessary.
Check battery for cracks and leaks. Ensure cables
are tight. Tighten as necessary.
Check battery box for damage.
Check cables for damage. Replace as necessary.
2
Bucket
Check all mounting hardware for looseness. Tighten
as required. All locknuts may only be tightened
once and are not to be reinstalled.
3
Hand Control
Check harness connection nut at bottom of hand
control for looseness. Tighten as required.
Check heat shrink material for deterioration. Refer
to direct support maintenance.
Check switch mounting nuts for tightness. Tighten
as required.
Check hand control for obvious damage. Replace as
necessary (para 4-38).
Check indicators and switches for operation. Replace
hand control (para 4-38).
4
Key Switchbox
Check box for security in mounting. Tighten as
required.
Check for obvious external damage.
Check fuse in key switch panel. If fuse is faulty,
replace.
5
Hydraulic
Check mounting hardware for security. Tighten as
Reservoir and
required.
Fuel Tank
Check mounting tabs on frame for cracks at
welded seams and mounting holes for elongation.
Refer to direct support maintenance.
Check hydraulic reservoir sight gage for damage.
Replace reservoir (para 4-34).
Check fuel tank sediment bowl for damage. Replace
bowl (para 4-28).
4-4