TM 5-3740-214-14
Table 5-3. Direct and General Support Maintenance Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE STOPS SUDDENLY (Continued)
c.
Check the breaker point gap.
(1)
Shut the ignition switch OFF.
(2)
Crank the engine by hand until the points are open to their widest gap.
(3)
If the gap is 0.020 inches (0.52 mm) the gap is ok. Go to Step 7.
(4)
If the gap is greater than or less than 0.020 inches (0.52 mm) go to Step 6d.
Figure 5-108. Gapping Breaker Points
d.
Reset the breaker point gap.
(1)
Rotate the engine by hand until the breaker points reach their greatest gap.
(2)
Loosen the point gap adjustment screw and place an 0.020 inch (0.52 mm) feeler gage between
the points.
(3)
Tighten the adjusting screws after setting the gap.
(4)
Replace the breaker point cover and go to Step 6e.
e.
Start the engine.
(1)
If the engine starts, the problem is solved.
(2)
If the engine does not start, go to Step 7.
5-97
