238AFMAN 24-204(I)/TM 38-250/NAVSUP PUB 505/MCO P4030.19H/ DLAI 4145.311 DECEMBER 2001A8.12.3. Package in steel drums (1A1 or 1A2) with a gross weight not exceeding 150 kg (331 pounds) each.A8.12.4. Package in fiber (1G) or plywood (1D) drums with inner metal receptacles that have a positive (notfriction) means of closure. Inner metal receptacles must not contain more than 15 kg (33 pounds) each.A8.13. Films, Nitrocellulose Base (gelatin coated [except scrap]).A8.13.1. Package in steel drums (1A2), aluminum drums (1B2), steel jerricans (3A2), wooden boxes (4C1, 4C2),plywood boxes (4D), reconstituted wood boxes (4F), or plywood drums (1D) with each reel in a tightly closed metalcan, polypropylene cannister, or strong fiberboard inner packaging with its cover securely held in place withadhesive tape or adhesive paper.A8.13.2. Package in a fiberboard box (4G) or fiber drum (1G) with a single tightly closed metal can, polypropylenecannister, or strong fiberboard inner packaging with cover securely held in place with adhesive tape or adhesivepaper. This type packaging authorized only for film not exceeding 600 m (1969 feet).A8.14. Fusee (railway or highway).A8.14.1. General Requirements. Fusees that are equipped with spikes must have reinforced ends to preventpenetration of the spikes through the outer packaging. Also, the packages must be capable of passing at least onedrop test with the spike in a downward position. The PSN "FUSEE" is only valid for domestic movement. Forinternational shipment you must use the PSN "SIGNAL DEVICES, HAND" and package the material as required bythe packaging paragraph for signal devices, hand.A8.14.2. Packaging Requirements. Package fusees (railway or highway) in steel drums (1A2), steel jerricans(3A2), wooden box (4C1, 4C2), plywood box (4D), reconstituted wood box (4F), fiberboard box (4G), plywooddrum (1D), or fiber drum (1G).A8.15. Matches, Fusee; Matches, Safety (book, card, or strike-on-box); Matches Strike-Anywhere, andMatches, Wax Vesta.Matches must be of a type that will not ignite spontaneously when subjected to a temperatureof 93.3 degrees C (200 degrees F) for 8 consecutive hours in a properly conducted laboratory test.A8.15.1. Do not pack matches, strike-anywhere, in the same outside container with any other article except safetymatches or wax vesta matches. The safety matches or wax vesta matches must be packaged in separate insidecontainers. Package matches, strike-anywhere in a steel drum (1A2), aluminum drum (1B2), steel jerrican (3A2),wooden box (4C1, 4C2), plywood box (4D), reconstituted wood box (4F), fiberboard box (4G), plywood drum (1D),or fiber drum (1G) with inside securely closed chipboard, fiberboard, wooden, or metal inner containers. Eachinside packaging must not contain over 700 matches. Gross weight must not be over 27.2 kg (60 pounds) forfiberboard boxes or 45.4 kg (100 pounds) for all other outer packagings.A8.15.2. Do not pack fusee matches, in the same outside container with any other article except safety matches orwax vesta matches. The safety matches or wax vesta matches must be packaged in separate inside containers.Package fusee matches in a steel drum (1A2), aluminum drum (1B2), steel jerrican (3A2), wooden box (4C1, 4C2),plywood box (4D), reconstituted wood box (4F), fiberboard box (4G), plywood drum (1D), or fiber drum (1G) withinside securely closed chipboard, fiberboard, wooden, or metal inner containers. Each inside packaging must notcontain over 700 matches. Gross weight must not be over 27.2 kg (60 pounds) for fiberboard boxes or 45.4 kg (100pounds) for all other outer packagings.A8.15.3. Tightly pack safety matches (strike-on-box, book, and card) or wax vesta matches in securely closedinside containers then packed in a steel drum (1A2), aluminum drum (1B2), steel jerrican (3A2), wooden box (4C1,4C2), plywood box (4D), reconstituted wood box (4F), fiberboard box (4G), plywood drum (1D), or fiber drum(1G). Safety matches may be packed in the same outside container with non hazardous materials.A8.16. Pentaborane. Package in any DOT specification cylinder, except those specified for acetylene.A8.17. Phosphorus, White or Yellow, Dry, or Under Water, or in Solution. The packaging requirements are:A8.17.1. Phosphorus white or yellow, when dry, must be cast solid and shipped in containers as follows:A8.17.1.1. Steel drums (1A2) not over a 115 L (30 gallons) capacity each.A8.17.1.2. In projectiles or bombs without bursting elements.A8.17.2. Pack phosphorus, white or yellow, when in water or solution, in:A8.17.2.1. Wooden boxes (4C1, 4C2, 4D, or 4F) with inside soldered or hermetically-sealed metal cans placedinside another soldered or hermetically-sealed metal can.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
