2-47. FUEL PUMP AND IGNITION DRIVE MOTOR.
This task covers:
a. Disassembly
c. Reassembly
b. Repair
INITIAL SETUP
Tools and Special Tools
Equipment Condition
Automotive Maintenance and Repair Field Maintenance
Fuel pump and ignition drive motor removed from skid assembly. Refer to
Shop Equipment, Basic, Less Power (SC 4910-95-CL-A31)
paragraph 2-45 for disassembly/reassembly procedures.
LOCATION/lTEM
ACTION
REMARKS
Fuel Pump and Ignition
Drive Motor/
Machine screw (1)
Unscrew and remove four machine screws (1), four lock washers (2),
Fuel pump and ignition drive motor is shown sepa-
Lock washer (2)
cover (3), and gasket (4). Inside of opening, remove machine screw (5),
rated for illustration purposes only. The torsion helical
and lock washer (6). Remove electrical contact brush (7) by lifting torsion
Cover (3)
springs (8) and electrical contact brushes (7) will be
helical spring (8). Repeat this procedure to disassemble the electrical
Gasket (4)
removed and reinstalled through the opening under
Machine screw (5)
contact brush on the other side of the direct current motor.
cover (3).
Lock washer (6)
Electrical contact brush (7)
Torsion helical spring (8)
TM 3-4230-209-30&P