TM 3-4230-209-30&P
2-212
2-46. COMBUSTOR
MAGNETO (CONT).
REMARKS
ACTION
LOCATION/lTEM
Combustor Magneto/
Replace authorized unserviceable parts.
Repair ignition distributor cap (1) by replacing ignition terminal sleeve (2).
Ignition distributor cap (1)
Ignition terminal sleeve (2)
Minor pitting of distributor contact set (3) points may be repaired by using
Distributor contact set (3)
crocus cloth. Care must be taken to make sure that contact point face
surfaces are flat and that all the face surfaces contact squarely.
Combustor Magneto/
Fixed capacitor (1) and distributor contact set (4) are
Position fixed capacitor (1) onto the mounting plate. Insert machine
Fixed capacitor (1)
component parts of the ignition magneto parts kit.
screw (2) through lock washer (3) and fixed capacitor (1). Screw into the
Machine screw (2)
mounting plate and tighten.
Lock washer (3)
Distributor contact set (4)
Assemble distributor contact set (4) by connecting the wires from the
Machine screw (5)
magneto and fixed capacitor (1) to distributor contact set (4) with machine
Flat washer (6)
screw (5), flat washer (6), and nut (7). Tighten the screw connecting the
Nut (7)
wires to distributor contact set (4).
Position distributor contact set (4) onto the mounting plate and install
Retaining ring (8)
retaining ring (8). Insert machine screw (9) through lock washer (10), flat
Machine screw (9)
washer (11), and into distributor contact set (4). Then screw into the
Lock washer (1O)
mounting plate. Do not tighten fully.
Flat washer (11)
