TM 3-4230-209-30&P
2-216
2-47. FUEL PUMP AND IGNITION DRIVE MOTOR (CONT).
REMARKS
ACTION
LOCATION/lTEM
Replace authorized unserviceable parts.
Fuel Pump and Ignition
Drive Motor/
Replace electrical contact brushes (1), in pairs when a brush measures
Contact brush (1)
1/4 inch long or less.
Fuel Pump and Ignition
Drive Motor/
Pull upon torsion helical spring (1) and insert electrical contact brush (2).
Torsion helical spring (1)
Insert machine screw (3) through lock washer (4), and the terminal end of
Electrical contact brush (2)
electrical contact brush (2). Screw machine screw (3) into the attachment
Machine screw (3)
point in the end shell of the motor and tighten.
Lock washer (4)
Gasket (5)
Position gasket (5) and cover (6) together. Insert four machine screws (7)
Cover (6)
through four lock washers (8), cover (6), and gasket (5). Screw machine
Machine screw (7)
screws (7) into the end shell of the motor and tighten. Repeat this proce-
Lock washer (8)
dure to reassemble the electrical contact brush on the other side of the
fuel pump and ignition drive motor.