TM 3-4230-209-30&P
2-88
2-20. SKID BASE SUBASSEMBLY (CONT).
REMARKS
ACTION
LOCATION/ITEM
Skid Base Subassembly/
WARNING
Unless it is securely blocked, never reach under the skid
base subassembly while it is raised off the floor. Failure to
comply may result in a crushed arm.
Raise and block skid base subassembly in accordance with local policy.
Position generator support (50) onto skid over the two holes near center
Generator support (50)
and insert two hexagon head cap screws (51 ) through flat washers (52),
Hexagon head cap
terminal on ground wire (53) generator support (50), and the skid.
screws (51)
Flat washer (52)
Ground wire (53)
Reach under skid and install two internal tooth lock washers (54) and
Internal tooth lock
hexagon plain nuts (55) to secure.
washer (54)
Hexagon plain nut (55)
NOTE
Final adjustment of generator
support (50) will be required
after the alternator-generator
V belts have been installed.
The mount will have to be
adjusted so V belt will track
correctly in the pulley groove.
A misalined mount will cause
belt to be thrown off of pulley
or cause excessive wear on
belts.
