TM 10-5410-228-24
LIGHTWEIGHT MULTIPURPOSE SHELTER (LMS).
LMS Air Duct Replacement.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
Drill, Electric (Item 6, Appendix B)
References:
TM 10-5411-224-14
Drill Set (Item 5, Appendix B)
Goggles (Item 17, Appendix B)
Materials/Parts:
Riveter, Blind, Hand (Item 34, Appendix B)
Ten Blind Rivets (Item 137 Appendix E)
Collar Set, Drill Stop (Item 2, Appendix B)
a. Removal (Refer to Figure 3-3)
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
NOTE
Reference TM 10-5411-224-14 for general repair procedures using rivets.
(1)
Drill out ten rivets (1) securing air duct (2) to LMS front wall (3).
(2)
Remove six screws (5), six lockwashers (6) and six flat washers (7) and pull air duct (2) from
LMS roof fastener loop (4).
b. Installation (Refer to Figure 3-3)
NOTE
Reference TM 10-5411-224-14 for general repair procedures using rivets.
(1)
Secure air duct (2) to LMS roof fastener loop (4) with six screws (5), six lockwashers (6) and six
flat washers (7).
(2)
Install air duct (2) to LMS front wall (3) with ten rivets (1).
