TM 10-5410-228-24
2.13.8 Electrical Raceway Replacement Continued.
(14) Remove two connectors (37) securing conduit (38) to light box and receptacle panel.
(15) Disconnect wiring from receptacle panel per para 2.13.30.
(16) Remove conduit (38) from LMS.
b. Assembly (Refer to Figure 2-29)
(1)
Install wiring in conduit (38).
(2)
Connect wiring to receptacle panel per para 2.13.30.
(3)
Attach conduit (38) to light box and receptacle panel with two connectors (37).
(4)
Apply antiseize compound to screws (32). Secure conduit (38) to LMS with two pipe straps (35),
two pipe spacers (36), two screws (32), two new lockwashers (33) (Item 17, Appx E) and two flat
washers (34).
NOTE
Reference TM 10-5411-224-14 for general repair procedures using rivets.
(5)
Secure rear raceway (29) to LMS with seven rivets (28) (Item 78, Appx E).
(6)
Secure rack raceway (27) to LMS with two rivets (26) (Item 77, Appx E).
(7)
Install modified elbow (25).
(8)
Secure driver side front raceway (19) to LMS with seven rivets (20) (Item 78, Appx E) and eight
rivets (21) (Item 77, Appx E).
(9)
Install internal elbow (18).
(10) Secure coupler (17) to internal elbow (18) and driver side front raceway (19) with two screws
(16).
(11) Secure top left front raceway (15) to LMS with five rivets (14) (Item 77, Appx E).
(12) Install three elbows (13).
(13) Secure storage box raceway (12) to LMS with five rivets (11) (Item 77, Appx E).
(14) Install cable assemblies.
(15) Install eleven 3300 wire retainers (9) and three 2200 wire retainers (10).
(16) Install cover assembly (2), raceway covers (3, 4, 5 and 6), rear raceway cover (7) and three elbow
covers (8).
(17) Install nine cover clips (1) to electrical raceway.
2-180
