TM 10-5410-228-24
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
Stowed equipment removed.
Drill, Electric (Item 6, Appendix B)
Drill Set (Item 5, Appendix B)
References:
TM 10-5411-224-14
Goggles (Item 17, Appendix B)
Riveter, Blind, Hand (Item 34, Appendix B)
Materials/Parts: (Cont.)
Collar Set, Drill Stop (Item 2, Appendix B)
Two Lockwashers (Item 19, Appendix E)
Forty-eight Solid Rivets (Item 72, Appendix E)
Materials/Parts:
Two Lockwashers (Item 17, Appendix E)
Two Rivets (Item 80, Appendix E)
One Hundred Seventy Lockwashers (Item 18,
Two Blind Rivets (Item 81, Appendix E)
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Removal (Refer to Figure 2-26)
(1)
Remove two screws (1), two lockwashers (2) and two flat washers (3) securing door bracket (4) to
interior driver side floor of LMS. Discard two lockwashers (2).
NOTE
The following step is typical for removal of ring assemblies on both the driver side and
passenger side in LMS.
(2)
Remove nut (5), lockwasher (6), two flat washers (7), ring assembly (8) and flat washer (9) from
LMS. Discard lockwasher (6).
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
(3)
Drill out two rivets (10) securing strap assembly (11) to exterior of door assembly (12).
(4)
Drill out two rivets (13) securing mounting strap (14) to interior of emergency exit door
assembly (15).
NOTE
The following steps are typical for removal of all remaining LMS straps.
(5)
Remove four screws (16), four lockwashers (17) and four flat washers (18) securing mounting
plate (19) to LMS. Discard four lockwashers (17).
