TM 10-5410-228-24
2.13.4 Window Replacement.
This task covers:
a. Disassembly
b. Assembly
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
References:
Caulking Tool, Hand (Item 18, Appendix B)
TM 10-5411-224-14
Drill, Electric (Item 6, Appendix B)
Drill Set (Item 5, Appendix B)
Goggles (Item 17, Appendix B)
Riveter, Blind, Hand (Item 34, Appendix B)
Collar Set, Drill Stop (Item 2, Appendix B)
Materials/Parts: (Cont.)
Materials/Parts:
Adhesive (Item 6, Appendix C)
Sealer (Item 50, Appendix C)
Isopropyl Alcohol (Item 12, Appendix C)
Twenty-eight Blind Rivets (Item 77, Appendix E)
Rubber Gloves (Item 25, Appendix C)
Twenty Blind Rivets (Item 78, Appendix E)
Wiping Rags (Item 39, Appendix C)
Twenty-eight Blind Rivets (Item 82, Appendix E)
NOTE
The following maintenance procedures can be used for both passenger side and driver side
windows.
a. Disassembly (Refer to Figure 2-25)
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
(1)
Drill out two rivets (1) and four rivets (2) securing interior frame segment (3) to LMS.
(2)
Drill out four rivets (4) and two rivets (5) securing interior frame segments (6) to LMS.
(3)
Drill out twenty rivets (7) and sixteen rivets (8) securing two interior frame segments (9) to
LMS.
NOTE
If the window is leaking, remove gaskets.
(4)
Remove four gaskets (10), four gaskets (11) and safety glass (12) from LMS. Discard eight
gaskets (10 and 11).
(5)
Drill out 28 rivets (13) securing exterior frame (14) to LMS and remove exterior frame (14).
Change 1
