TM 10-5410-228-24
2.11.1 Compartment Guard Replacement.
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
Drill, Electric (Item 6, Appendix B)
References:
TM 10-5411-224-14
Drill Set (Item 5, Appendix B)
Goggles (Item 17, Appendix B)
Riveter, Blind, Hand (Item 34, Appendix B)
Materials/Parts:
Sealant (Item 47, Appendix C)
Qty varies Lockwashers (Item 17, Appendix E)
Self-locking Nut (Item 47, Appendix E)
Eight Blind Rivets (Item 78, Appendix E)
NOTE
The following procedures are for driver side access panel or passenger side access panel.
Hardware quantity varies from side to side.
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Removal (Refer to Figure 2-2)
(1)
Remove screws (1), lockwashers (2) and flat washers (3) securing guard (4) to LMS (5). Discard
lockwashers (2).
b. Disassembly (Refer to Figure 2-2)
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
(1)
Drill out four rivets (6) securing two latches (7) to ECV (8).
(2)
Remove seven rivet nuts (9) from LMS (5).
(3)
Remove self-locking nut (10) and two flat washers (11), securing latch (12) to stud (13) on
passenger side of LMS (5). Discard self-locking nut (10).
c.
Assembly (Refer to Figure 2-2)
(1)
Secure latch (12) to stud (13) on LMS (5) with two flat washers (11) and new self-locking nut
(10) (Item 47, Appx E).
