TM 10-5410-228-24
2.11.4 Hose Guard Replacement.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions:
Tools/Test Equipment:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
References:
TM 9-2320-387-24-1
Materials/Parts:
Three Lockwashers (Item 17, Appendix E)
Fourteen Lockwashers (Item 18, Appendix E)
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Removal (Refer to Figure 2-5)
(1)
Remove three screws (1), three lockwashers (2), three flat washers (3), bolt (4), lockwasher (5)
and flat washer (6) securing hose guard (7) to passenger side of LMS. Discard three lockwashers
(2) and lockwasher (5).
(2)
Remove three bolts (8), three lockwashers (9) and three flat washers (10) securing hose guard
(11) to passenger side of ECV. Discard three lockwashers (9).
(3)
Remove passenger side and driver side mirror mounts from ECV per TM 9-2320-387-24-1.
Remove two hose guards (12 and 13).
(4)
Remove ten screws (14), ten lockwashers (15), and ten flat washers (16) securing two hose
guards (17) to passenger side and driver side of ECU. Discard ten lockwashers (15).
b. Installation (Refer to Figure 2-5)
(1)
Secure two hose guards (17) to passenger side and driver side of ECU with ten screws (14), ten
new lockwashers (15) (Item 18, Appx E) and ten flat washers (16).
(2)
Position two hose guards (12 and 13) between ECV and two mirror mounts. Install passenger
side and driver side mirror mounts on ECV per TM 9-2320-387-24-1.
(3)
Secure hose guard (11) to passenger side of ECV with three bolts (8), three new lockwashers (9)
(Item 18, Appx E) and three flat washers (10).
(4)
Secure hose guard (7) to passenger side of LMS with three screws (1), three new lockwashers (2)
washer (6).
