TM 10-5410-228-10
Personnel riding in LMS must remain seated with seat belts fastened during ECV
movement.
(4)
This completes switchover from NBC to non-NBC conditions for mobile mode operation.
Operate system as mission requires.
2.25.2 Static Operation Under NBC Conditions.
2.25.2.1
Expanded Capacity Vehicle (ECV) and High Mobility Trailer (HMT) Setup.
a. Cab Crew Tasks
Cab crew must be in full MOPP gear.
Refer to section 2.24.2.1, Expanded Capacity Vehicle (ECV) and High Mobility Trailer (HMT) Setup.
b. LMS Crew Tasks
ESS MODE selector switch must be on VENT, HEAT or COOL for ESS to function.
LMS crew must wear chemically protective masks.
Ensure access door and emergency exit hatch are closed and latched.
Remain in LMS with system running and wait for signal from cab crew.
2.25.2.2
Deployment Using Internal (ECV) Power.
a. Cab Crew Tasks
Refer to section 2.24.2.2, Deployment Using Internal (ECV) Power.
b. LMS Crew Tasks
System should be running with POWER MODE switch set to INT, and HEAT/COOL,
NBC/VENT, INSTM CONT and LTG/INTERCOM circuit breakers ON.
(1)
Listen for EPG engagement, indicated by a change in ECV engine speed. After EPG is engaged,
perform the following steps.
(2)
On rear control panel (1, figure 2-35), ensure the following circuit breakers are ON:
OUTLET ASSY (2)
HEAT/COOL (3)
NBC/VENT (4)
INSTM CONT (5)
LTG/INTERCOM (6).
(3)
Set inverter (7) power switch (8) to ON.
2-119
