TM 10-5410-228-10
2.24.3.3
Static Mode Shut Down Procedure - External (10 kW TQG) Power - Continued.
b. Cab Crew Tasks
(1)
Turn power panel (rear, driver side) circuit breaker OFF.
(2)
Shut off TQG in accordance with TM 9-6115-642-10 or applicable manual.
(3)
Disconnect TQG power cable from LMS power panel and ground leads to ground stake. Remove
ground stake and store on HMT as required.
(4)
This completes shut down in static mode using external power. Proceed to para 2.24.3.4 for
HMT hookup.
2.24.3.4
High Mobility Trailer (HMT) Hookup.
a. Cab Crew Tasks
Do not attempt to lift HMT tongue alone if HMT is heavily loaded. Lifting heavy HMT
tongue alone can cause back injury. Use crank on front caster to raise HMT tongue.
(1)
On HMT (1, figure 2-33), raise rear support leg (2) off ground by turning leg extension (3) so
that it clears ground by about six inches.
(2)
Crank down caster (4) on front support leg (5) so tongue ring (6) is raised up to clear pintle hook
(7) on ECV.
(3)
Maneuver ECV into position to hook up HMT (1).
(4)
Open pintle hook (7) on ECV by removing safety pin (8) and lifting top locking latch (9).
(5)
Lower HMT tongue ring (6) onto ECV pintle hook (7) by cranking up caster (4). Close locking
latch (9) and insert safety pin (8).
(6)
Connect light cable (10), breakaway brake chain (11) and safety chains (12) to ECV.
(7)
Raise front support leg (5) and lock in place with pin (13).
(8)
Raise rear support leg (2) and lock in place with pin (14).
(9)
Release parking brakes (15) on HMT (1).
(10) This completes HMT (1) hookup. Operate CBPS as required.
b. LMS Crew Tasks
No tasks required.
2-114
