TM 10-5410-228-10
(2)
Ensure that access door and emergency exit hatch are closed and latched.
2.24.1.3
Mobile Mode Shut Down Procedure.
a. LMS Crew Tasks
(1)
Set ESS MODE selector switch (8, figure 2-3) to OFF.
(2)
Set lights to OFF (if necessary).
(3)
On rear control panel (1), set circuit breakers (3 through 6) to OFF.
b. Cab Crew Tasks
(1)
Put transmission in park, apply parking brake and turn off ECV lights and engine (refer to TM
9-2320-387-10).
(2)
This completes shut down for mobile mode operation.
2.24.2 Static Operation.
NOTE
The procedural steps for setting up the CBPS under non-NBC conditions and under NBC
conditions are essentially the same, except for installing the ambulatory and TALP airlock
doors. Steps and procedures, as provided herein, are for operating under non-NBC
conditions.
2.24.2.1
Expanded Capacity Vehicle (ECV) and High Mobility Trailer (HMT) Setup.
a. Cab Crew Tasks
(1)
Select CBPS site on level, dry ground in clear area approximately 50 feet by 100 feet with at
least 15 feet of overhead clearance.
(2)
If possible, CBPS should be set up with the ECV pointing into the wind.
(3)
Determine parking area for ECV. Park HMT 4 to 6 feet from driver side of ECV with wheels of
HMT in line with front wheel of ECV.
(4)
Apply parking brakes (1, figure 2-4) on HMT (2).
(5)
Lower front support leg (3) and lock in place with pin (4). Disconnect light cable (5), breakaway
brake chain (6) and safety chains (7) from ECV.
To prevent HMT from tilting backwards and causing injury to personnel, lower rear support
leg and secure with pin.
(6)
Lower rear support leg (8) and secure with pin (9).
(7)
Open pintle hook (10) on ECV by removing safety pin (11) and lifting top locking latch (12).
(8)
Crank down caster (13) on front support leg (3) so that tongue ring (14) is raised up to clear
pintle hook (10).
2-65
