SHUTDOWN PROCEDURES (Continued)
(f) Turn the cap bracket back up and tighten the cap knob.
Figure 2-36. Nozzle Adjustment Procedure
(4) Turn the nozzle down and aim it into a bucket.
(a) Loosen the elbow adjusting nut and turn the elbow to the desired position.
(b) Tighten the elbow adjusting nut.
(c) Loosen the nozzle adjusting nut and turn the nozzle down and aim it into a bucket.
(d) Tighten the nozzle adjusting nut.
(5) Pressurize the formulation tank.
(a) Make sure the solenoid valve switch is turned OFF.
(b) Turn the three-way valve to the flush position.
MAKE SURE there are no personnel in front of the nozzle before starting the engine.
(c) Turn the engine ignition switch ON and push the start button until the engine starts.
(d) When the tank pressure levels off shut the ignition switch OFF.
(e) Open the flow meter control needle valve.
(g) Turn the three-way valve to the ULV position.