TM 5-6635-386-12&P
NOTE
Pushing any Operations key will immediately restart tester
and will supersede prior command.
D - DATA
=
Displays Density count.
M - DATA
=
Displays Moisture count.
D - STD
=
Displays Density standard count.
M - STD
=
Displays Moisture standard count.
Upon initial operation after a period of nonuse, press the
CLEAR key to clear out any unwanted commands.
Press any of the four OPERATIONS keys to start the
tester for normal density and moisture counting. All
displays will be normalized to a 1/4 minute count base for
simplicity of computation.
At the completion of any count cycle, the tester will
"beep-beep" rapidly for ten beeps.
During the count cycle, a pulsing "beep" will be heard
If the batteries are low, but still useable, an "L" will
appear in the display window. If the batteries are below
acceptable charge level, the "L" will display, but the
tester will "Cutout" and will not operate. Recharge the
tester overnight when the batteries indicate "L" or low.
Figure 1-1. Keyboard Configuration
1-6
