TM 5-6350-264-14&P-10NAVELEX EE 181-AA-OMI-110/E121 C-9412T.O. 31S9-2FSS9-1-10Table 5-2. Troubleshooting Procedures - ContinuedTroubleProbable causeCorrective action1.(Cont)d.(Cont)it contacts receptacle at back ofprocessor. Then press firmly onboard until it seats completely inreceptacle.(3) Turn on switch S1 on power sup-ply. Depress TRANSMITTERRESYNC switch S2. Wait about5 minutes for system to stabilize.Turn mode switch to TEST/RESET and then to SECURE.m. If meter indicates less than 1 vdc at J10-7,replace PC board A10.(1) To remove PC board A10, turn offswitch S1 on top of power supply.Place thumb or finger under boardejector and lift up until board popsout of receptacle at back of statusprocessor. Then grasp PC boardand pull straight out.(2) To install new PC board A10, turnboard so plastic ejector is towardtop. Align board with guides attop and bottom of status proces-sor. Slide board straight in untilit contacts receptacle at back ofprocessor. Then press firmly onboard until it seats completely inreceptacle.(3) Turn on switch S1 on power sup-ply. Depress TRANSMITTERRESYNC switch S2. Wait about5 minutes for system to stabilize.Turn mode switch to TEST/RE-SET and then to SECURE.n.Set mode switch to ACCESS. Set multi-meter to dc volts and connect positivelead to PC board A10, TP1 (brown), andnegative lead to chassis (ground).o.If meter indicates less than 1 vdc, con-nect positive meter lead to mode switch5-23
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
