TM 5-6350-264-14&P-10NAVELEX EE 181-AA-OMI-110/E121 C-9412T.O. 31S9-2FSS9-1-10Table 5-1. Maintenance Controls and IndicatorsControls/indicatorsFunctionDuress/intrusion alarmLight-emitting diodes (LED) illuminate to indicate thedisplayfirst duress or intrusion alarm input.Terminal Board A12Diode(Alarm input)FF (duress)AA (intrusion)BB (intrusion)CC (intrusion)DD (intrusion)EE (intrusion)NOTEDisplay is reset by moving operating modeswitch to ACCESS OR TEST/RESET, thenback to SECURE.LATCH/NON-LATCHControls mode of operation for the delayed alarm output(2-position toggle switch)output at terminal S1-D as follows:LATCH position - normal operating position. This per-mits latched alarm conditions to remain until reset bypositioning operating mode switch to TEST/RESET.NON-LATCH position - limits latched alarm output atterminal S1-D to 10+2 seconds after alarm disappears.Transmitter RESYNCWhen pressed, resynchronizes operation of Data Trans-(push-button switch)mitter and Data Receiver. Refer to TM 5-6350-264-14/12 & P.Power (2-position toggleConnects ac power and emergency battery power toswitch)Control Unit power supply.Tamper switchInitiates alarm signal when CU door is opened. Pullingswitch plunger all the way out disables the switch.5-7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
