TM 5-3740-218-13&P
MOTOR AND SLINGER ASSEMBLY REPLACEMENT (CONT)
C.
INSTALLATION
(1)
Install motor and slinger assembly (1) under bucket and secure to engine platform (2) with four screws (3),
eight washers (4), and four nuts (5).
(2)
Using 3/8-in. open-end box-end wrench, loosen two chute inner bolts (6) to align and/or adjust chute up and
down, and 3/8-in. socket-end wrench to loosen nut on lower bracket (7) to pivot slinger/chute assembly (8).
This adjustment allows free motion of hopper and slinger.
(3)
Remove cap and connect 3/4-in. hose (9) to quick-disconnect fitting (10) on back of hydraulic filter.
(4)
Remove cap and route 1/2-in. hydraulic hose (11) under throttle cable and in front of secondary hydraulic
manifold (12) and remove cap. Connect hose (11) to front bottom quick-disconnect fitting (13) on primary
hydraulic manifold (14).
(5)
Remove caps and connect two 1/4-in. hydraulic fittings (15 and 16) to back of secondary hydraulic manifold
(12), matching markings on fittings with markings on manifold.
(6)
Remove caps and connect four hydraulic fittings (17) to two hopper cylinders (18).
(7)
Spin slinger assembly (1) to ensure freedom of movement.
4-144
