TM 5-3740-218-13&P
4-38. HAND CONTROL ASSEMBLY/ELECTRICAL-SAFETY CABLE ASSEMBLY
REPLACEMENT
This task covers: Removal
Installation
A. INITIAL SETUP
Tools and Special Equipment:
Materials/Parts:
Tool Kit, 5180-00-177-7033
Tie, Cable
Appendix E, Item 62
B.
REMOVAL
NOTE
If hand control assembly fails to operate properly or
if inspection indicates replacement is necessary,
perform the following steps.
(1) Disconnect electrical-safety cable assembly (1) from bucket harness connector (2) by pulling electrical-safety
cable assembly quick-disconnect connector (3).
(2) Disconnect electrical-safety cable assembly (1) from hand control assembly (4) by turning electrical-safety
cable assembly connector (5) counterclockwise.
(3) Disconnect safety cable assembly (6) from electrical-safety cable assembly (1) by removing screw (7) and
washer (8) from fork (9).
(4) Remove and discard cable ties (10).